Results 1 to 13 of 13

Thread: near terminal or terminal packing?

  1. Header
  2. Header-59

BLiNC Magazine, always served unfiltered

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    speed
    Guest

    near terminal or terminal packing?

    When I watch those videos of the big wall jumps. I notice they are still using mesh sliders. I assume from the delay they are near terminal or at terminal.

    So my question is, Would a nose exposed mesh slider pack job be acceptable for a terminal opeing?

    Do you pack the same for a 6 sec delay as you would for longer delay off a wall, ie near or at terminal?

    In short I peformed a base pack job on my canopy and I am going to peform a hop-pop at the DZ. I am toy'n with the idea to take it to terminal. It may hurt but I just dont want it to kill me :)

    Thanks for sharing you info


  2. #2
    Jolly Jumper
    Guest

    RE: near terminal or terminal packi

    Do you intend to use a skydivechute? dont !!!
    dacron or other microlines dont stretch!!!!
    otherwise i jump most of my jumps terminal/noseexp/meshslider and I am still alive!!

  3. #3
    speed
    Guest

    RE: near terminal or terminal packi

    Its my a big cushy base canopy. :P I want to jump in my skydiving container to test higher speed deployments, but I wasnt sure if I should take it to terminal.

    Thanks I think you answered my question. ;-)

  4. #4
    Jolly Jumper
    Guest

    RE: near terminal or terminal packi

    Please remember to rubberband the slider!!!!!!


  5. #5
    Eddy
    Guest

    RE: near terminal or terminal packi

    Can you tell me what the slider bungee adds to the quality of the pack job please.

    When is it best employed?

    I used to have one on my slider to take a bite in break lines on a skydive cnopy - to add break line control to my crap pro-packs.

    Thanks:o

  6. #6
    imported_Tom Aiello
    Guest

    RE: near terminal or terminal packi

    >Can you tell me what the slider bungee adds to
    >the quality of the pack job please.

    The bungee (rubber band to Americans) (direct control) on the slider apex holds it tight in the pack job until the pack job reaches line stretch. This can also be achieved using indirect control (i.e. that stow just underneath the tailpocket).

    The theory is that the lines are fully taught before the slider begins to come down, allowing the slider to move down the lines as cleanly and quickly as possible, contributing to more symmetric deployment and discouraging off headings.

    >When is it best employed?

    Most people prefer to use it at terminal. Some people never use it, and some people use it all the time.

    I personally use direct control unless I am deploying very low, or the jump is very subterminal and I am using a slider to stage a multi-way deployment.

    >I used to have one on my slider to take a bite
    >in break lines on a skydive cnopy - to add break
    >line control to my crap pro-packs.

    This technique has been used on and off by some BASE jumpers for some time. Old Mojo sliders include this stow, as do the Dagger sliders I have seen. To my knowledge, this technique is recommended by Vertigo, but not by CR or BR.

    --Tom Aiello
    tbaiello@ucdavis.edu

  7. #7
    guest
    Guest

    RE: near terminal or terminal packi

    Word.

    Even a 5 sec delay can bite you if you don't rubber band the slider.

    /Lukas

  8. #8
    guest
    Guest

    RE: near terminal or terminal packi

    I have been jumping Maverick and Mojos, and have never rubber band my slider! My packing is the same for slider down or slider up, 160 m slider up I expose the nose a little bit more than when I jump big walls. I pull the center cell around the corners, and let the end cells lay flat under neat it, pointing outwards. I have tried to roll the end cells 2 - 3 times, but couldnt tell any difference. When I jump a new canopie, I do some few sub terminal jumps on it, before going terminal.

  9. #9
    BLiNC Magazine Supporter (Silver) crwper's Avatar
    Join Date
    Jan 1970
    Location
    Perigee Pro
    Posts
    381

    RE: near terminal or terminal packi

    So you don't pull the nose around the packjob when jumping big walls?

    Michael

  10. #10
    imported_mknutson
    Guest

    RE: near terminal or terminal packi

    That depends upon the pack job.

    I have never rubber banded my slider.
    See my post below.

  11. #11
    imported_mknutson
    Guest

    RE: near terminal or terminal...

    When I have been in Norway every year, I take the center cell and set it flat when dressing the nose, Then I take the 3 cells on either side and roll them 4-5 time, and lay them on top of the center cell, essentially hiding the center cell.

    "disclaimer"
    I am not a rigger, and strongly recommend you get to a MFG to verify this, but it works for me.

  12. #12
    BLiNC Magazine Supporter (Silver)
    Join Date
    Oct 2002
    Posts
    25

    RE: near terminal or terminal...

    i am not a rigger either but i have always rolled the nose of my fox and hidden the center cell away when jumping in Norway.it is the way i was shown and it works well.

    but when jumping other walls not so big but still slider up between 6 and 10 secs i left the nose exposed but more than this i will always hide the nose away!!!

    peace love and mungbeans...7....xxxxxxx

  13. #13
    Staff Member
    Join Date
    Jan 1970
    Location
    Perigee/Gargoyle
    Posts
    516

    Neck probs

    After my canopy was not new (15jumps) I switched to a mesh slider, I am very happy with all of my openings except one on terminal delays, unfortunately, that one is a biggie, ruptured disc in my neck, resulting in my shoulder cramping up, radiating pain, numbness and now I am in physiotherapy trying to avoid surgery or looking like the hunchback of Notre Dame.
    But I love the other openings at terminal with mesh slider..
    take care,
    space

Similar Threads

  1. Terminal Height??
    By guest in forum The 'Original' BASE Board
    Replies: 11
    Last Post: May 19th, 2009, 06:20 PM
  2. Terminal
    By mknutson in forum BASEWiki
    Replies: 0
    Last Post: May 7th, 2009, 08:25 AM
  3. NOTICES for Italian terminal and sub-terminal walls
    By unclecharlie109 in forum The 'Original' BASE Board
    Replies: 9
    Last Post: September 27th, 2006, 04:33 PM
  4. PC for terminal jumps
    By crwper in forum The 'Original' BASE Board
    Replies: 9
    Last Post: June 10th, 2003, 09:31 PM
  5. Terminal packing?
    By Drew Eckhardt in forum The 'Original' BASE Board
    Replies: 15
    Last Post: February 25th, 2003, 08:15 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •